首页 / 产品中心 / LED水族灯电源&控制器 / LED电源

IP65 Aquarium light LED Driver 150W Constant Voltage LED Power Supply
  • IP65 Aquarium light LED Driver 150W Constant Voltage LED Power Supply
  • IP65 Aquarium light LED Driver 150W Constant Voltage LED Power Supply

IP65 Aquarium light LED Driver 150W Constant Voltage LED Power Supply

Suitable for LED lighting applications in dry or wet environment 

下一页: 暂无

上一页: 暂无

Universal AC input/full range

Bipolar patented non-flicker high PFC power supply function

High efficiency up to 88%

Protections: Short circuit/Over current/Over voltage

Cooling by free air convection

Type P90 LED Driver for use in Class 2

Compliance to worldwide safety regulations for lighting

3 years warranty

规格
MODEL   LT-2L-P90150-Y48V
OUTPUTDC VOLTAGE24-36V
RATED CURRENT RANGE≤4500mA
RATED OUT POWER Max 150W
RIPPLE&NOISE (max.) Note.1300mVp-p
INPUTVOLTAGE RANGE 100~240VAC 277VAC (277VAC for North America only)
FREQUENCY RANGE47~63Hz
POWER FACTORF>0.98/100VAC,PF>0.900/240VAC(Please refer to "Power Factor Characteristic" curve)
EFFICIENCY(full load 220V)88.0%
MAX AC CURRENT
2A
LEAKAGE CURRENT<0.75mA/240VAC
PROTECTIONOVER CURRENT95~108%
Protection type:Constant current limiting,recovers automatically after fault condition is removed
SHORT CIRCUITConstant current limiting,recovers automatically after fault condition is removed
OVER VOLTAGEmin 65-70V
Protection type:Shut down o/p voltage with auto-recovery or re-power on to recovery
ENVIRONMENTWORKING TEMP.-20~+40℃ (Refer to "Derating Curve")
WORKING HUMIDITY20~95% RH non-condensing
STORAGE TEMP.,HUMIDITY-40~+80℃,  10~95%  RH
EMP. COEFFICIENT±0.03%/℃ (0~50℃)
SAFETY & EMCSAFETY STANDARDS   ******
WITHSTAND VOLTAGEI/P-O/P:3.75KVAC 
ISOLATION RESISTANCEI/P-O/P,100M Ohms/500VDC/25℃/70% RH
EMC EMISSION  Note.3******
OTHERSDIMENSION******



PACKING******



NOTE1. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
2. Length of set up time is measured at cold first start. Turning ON/OFF the power supply may lead to increase of the set up time.
3. To fulfill requirements of the latest ErP regulation for lighting fixtures, this LED power supply can only be used behind a switch without permanently connected to the mains.
评论
*
*
*
*
*
*
*
Top