首页 / 产品中心 / 可控硅调光电源 / 0-10V调光

30-60W 0~10V Dimmable and Non-flicker LED Driver with UL certificate
  • 30-60W 0~10V Dimmable and Non-flicker LED Driver with UL certificate
  • 30-60W 0~10V Dimmable and Non-flicker LED Driver with UL certificate
  • 30-60W 0~10V Dimmable and Non-flicker LED Driver with UL certificate
  • 30-60W 0~10V Dimmable and Non-flicker LED Driver with UL certificate
  • 30-60W 0~10V Dimmable and Non-flicker LED Driver with UL certificate
  • 30-60W 0~10V Dimmable and Non-flicker LED Driver with UL certificate

30-60W 0~10V Dimmable and Non-flicker LED Driver with UL certificate

Suitable for LED lighting applications with dry / damp circumstances

下一页: 暂无

上一页: 暂无

Universal AC input / Full range

Built-in active PFC function

High efficiency up to 86%

Protections: Short circuit / Over current / Over voltage

Cooling by free air convection

Type HD65 LED Driver for use in Class 2

Compliance to worldwide safety regulations for lighting

3 years warranty


规格
MODELHD6536-YA2HD6554-YA5
   OUTPUT         INPUTDC VOLTAGE27-40V27-40V
RATED CURRENT RANGE≤1000mA≤1400mA
RATED OUT POWERMax 40WMax 56W
DIMMING FUNCTION1-10V1-10V
RIPPLE & NOISE (max.) Note.1VOLTAGE RANGE300mVp-p300mVp-p
100~240VAC 277VAC (277VAC for North America only)
FREQUENCY RANGE47~63Hz
POWER FACTOR PF>0.98/100VAC, PF>0.95/240VAC (Please refer to "Power Factor Characteristic" curve)
EFFICIENCY(full load 220V)84.0%86.5%
MAX AC CURRENT                 0.6A0.8A
LEAKAGE CURRENT<0.75mA / 240VAC
   PROTECTION OVER CURRENT95 ~ 108%
Protection type : Constant current limiting, recovers automatically after fault condition is removed
SHORT CIRCUITConstant current limiting, recovers automatically after fault condition is removed
 OVER VOLTAGEMin 42V
rotection type : Shut down o/p voltage with auto-recovery or re-power on to recovery
   ENVIRONMENTWORKING TEMP.-20 ~ +40℃ (Refer to "Derating Curve")
WORKING HUMIDITY20 ~ 95% RH non-condensing
STORAGE TEMP., HUMIDITY-40~+80℃, 10~95% RH
TEMP. COEFFICIENT±0.03%/℃ (0 ~ 50℃)
   SAFETY &EMC    OTHERS SAFETY STANDARDSUL8750,CAN/CSA C22.2 No. 250.13
WITHSTAND VOLTAGEI/P-O/P:3.75KVAC
ISOLATION RESISTANCEI/P-O/P, 100M Ohms / 500VDC / 25℃/ 70% RH
EMC EMISSIONCompliance to EN55015,
DIMENSION *****
PACKING *******
NOTE
  1. 1.Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf &      47uf parallel capacitor.

  2. 2.Length of set up time is measured at cold first start. Turning ON/OFF the power supply may lead to increase of      the set up time.

  3. 3.The power supply is considered as a component that will be operated in combination with final equipment. Since     EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify    EMC Directive on the complete installation again.

  4. 4.To fulfill requirements of the latest ErP regulation for lighting fixtures, this LED power supply can only be used      behind a switch without permanently connected to the mains.




评论
*
*
*
*
*
*
*
Top